Misco VOC Compliant Polyurethane Wood Finish, 5 Gal

A high solids oil modified polyurethane finish designed for use on sports, commercialand residential wood floors. Produces outstanding durability and resistanceto scuffs, spills and stains. Leaves surface with an extremely rich highgloss that dirt and grime canʼt possibly penetrate. High solids make this productable to meet the strict VOC (Volatile Organic Compounds) requirements, whichhave been established in many states throughout the country. Easy to apply, it iscompatible over a wide variety of conventional solvent based coatings (providedthese coatings are cured, bonded and the floor is properly prepared).

Manufacturerʼs Recommendation: This coating is to be applied withoutthinning. VOC Content <350 grams/liter

ON NEW OR NEWLY PREPARED FLOORS: Use a good quality polyurethanesealer, following the directions for that product. Allow to dry thoroughly.

ON NEWLY SEALED FLOORS: Buff with a #120 abrasive screen. Clean surfacethoroughly with a tack rag and waterless cleaner and allow to dry. Applyfinish using a synthetic or lambʼs wool applicator, pressure sprayer or gravityfed applicator. If more than one coat is desired, allow 6 to 8 hours dry timebetween coats. No screening is required if recoating is done within 24 hours.Allow 72 hours cure time before allowing any foot traffic on floors (no dancesor similar events for at least one week).

NOTE:Best results are obtained with adequate ventilation and floor temperatureabove 60°F and below 95°F. Avoid direct drafts on floor while finishing.

CAUTION:Do not use on any resilient type flooring.

Pack : 5 GAL PAIL

Sold Per Pail

UPS Shippable Item